Search...
Menu
Homepage
OneVDLink R30
Connect to Third-party GCS
Connect to Third-party GCS
Confirm the flight controller's TELEM baud rate (default: 115200).
Enter the AT command on the master node.
Set the ground station IP.
Open the ground station software.
Click [Link Aircraft]
Click [Wireless Link]
Select [UDP]
In the remote address field, enter the air unit's IP address 192.168.1.100 (default is 192.168.1.12), and enter port 14551.
Click【OK】
Complete the link.
Share this Article
Previous
Quick Start Guide
Next
Serial Forwarding of RTK Base Station Data
Last modified: 2026-07-03
Powered by
AutoPilot Series
X6 AutoPilot
X6 AutoPilot Instruction
X6 AutoPilot Readme
X6 Air AutoPilot Series
X6 Air Series Instruction Manual
X6 Air+ AutoPilot Comparison
X6 Air V2 Series Flight Controller Documentation
X6 Pro AutoPilot
X6 Pro AutoPilot Instructions
X6 Ultra Autopilot
X6 Ultra AutoPilot Instruction
ZeroOne AutoPilot Parameter Comparison
X6、X6 Pro、 X6 Ultra AutoPilot Comparison Table
Q&A
OneRTK Series
OneRTK UM982
Overview & Specifications
Setup and Getting Started (ardupilot)
Setup and Getting Started (px4)
Building a Ground RTK Base Station
Q&A
OneRTK Pro
Product Overview
Using ardupilot firmware
Using PX4 firmware
Module extension configuration
Install and connect configuration software
View/record positioning data
Module performance optimization
Interface protocol configuration
OneRTK Ultra
Product Overview
Using Ardupilot Firmware
Using PX4 Firmware
Build a ground base station
OneRTK Ultra User Tutorial 2
OneGNSS Series
OneGNSS M9N
OneGNSS M9N Instruction
OneDLink P900/P840
OneDLink P900/P840 Documentation
P900 Configuration Guide
OneVDLink R30
OneVDLink R30 Networking Link User Manual
WebUI User Manual
Quick Start Guide
Connect to Third-party GCS
Serial Forwarding of RTK Base Station Data
OnePMU Series
OnePMU Power Module
OnePMU Instruction
User Guide
OneTube Heated Pitot Tube
OneTube Heated Pitot Tube Product Introduction
OneASP Series Airspeed Meters
OneASP Ultra Airspeed Meter
OneASP Ultra User Manual
OneASP Series Airspeed Meter Comparison Table
OneASP Pro User Manual
OneCompass RM3100
OneCompass Instruction Manual
How to use OneCompass
ArduPilot Firmware Tutorial
Internal RSC Governor
Parachute Tutorial
Helicopter parameter settings
Shutter configuration and hot shoe feedback
PX4 Firmware Tutorial
Px4 Multirotor Parameter Tuning Tutorial Ⅰ
Px4 Multirotor Parameter Tuning Tutorial Ⅲ
Px4 Multirotor Parameter Tuning Tutorial Ⅱ
Installing PX4 Firmware
OneRadar
OneRadar R82
OneRC R20
OneRC R20 Instruction Manual
Q&A
Analog ammeter setting
OneCam Gimbal Camera
OneCam D80 Pro Camera User Manual
OneCam Z10 Pro PTZ Camera
OneCam Z10 PTZ Camera
OneCam D90 AI Camera User Manual
OneVDLink R17
OneVDLink R17 Instruction
OneVDLink R17 Configure Guide
OneWLink
OneWLink Instruction
Product user manual
PX4 Release Notes
PX4 1.15 (stable) release notes
Peripherals
OneUBEC User Mannal
ArduPilot Tutorial
Quadrant Engine Connection and Configuration Guide
Powered by
Outline